CLEARVUE PANEL RAIL SYSTEM
overall product in place
The ClearVue Panel Railing System is an economical aluminum railing system that offers a new dimension in clear, tinted or translucent panels railings. A standard 1/2″ reglet is used to accept any 1/4″ thich infill panel (glass, expanded metal, wood, etc.). The infill panels are retained in the top and bottom rails with vinyl glazing sections (may be wet glazed at glaziers option). In addition to the variety of infill panels, ClearVue 350 can be supplied with three different top rails.
When all of the variations noted above are combined with the wide variety of finishes (painted or anodized) available for aluminum, the ClearVue Panel Rail Series offers dozens of possible railing configurations for your review.
FEATURES
- Economical
- Choice of Several Sizes and Styles
- Assembles Quickly
- Standard Mounting Hardware Available
typical sections
assembly details
A locking bar clamps the post sleeve to the top rail when the locking bolt is tightened. The sleeve is held in the post by two set screws. The bottom rail is retained within a hole bored through the post and locked from rotation with a tapered drive pin at one end. The bottom rail can be single lengths between the posts or a continuous rail through two or more posts. The pull in vinyl glazing is installed on one side of the top and bottom rails prior to assembly. The roll in vinyl glazing is rolled into place after the glass panels are set.
SUGGESTED SPECFICATIONS
1. SCOPE OF WORK
Furnish and install ClearVue 100 structural glass railing as manufactured by CraneVeyor Corp., South El Monte, CA.
2. MATERIAL DESIGN
Mounting shall be a one piece extruded aluminum alloy 6063-T6 (part number C46600). Structural base shall be anchored to deck per details shown on the architectural plans with 1/2″ stainless steel socket head cap screws at 12 inches on center. The railing shall be designed to withstand a lateral load across the top of the rail of 50 pounds per lineal foot. Tempered glass shall be 1/2″ thick and shall be float tempered with no tong marks. Exposed vertical edges of glass shall be polished. Top rail to be (specify size, shape and material with part number).
3. FINISH
- All exposed aluminum to be finished with one of the following:
- Class 1 clear anodized finish AA M12 C22 A41
- Class 1 bronze anodized finish AA M12 C22 A44
- Class 1 black anodized finish AA M12 C22 A44
- Hard Coat Anodize (Marine Environment) MIL-A-8625C, Type III, Class 1 with 0.0020″ minimum coating thickness
- Thermo setting paint (paint type and color to be selected by Architec
4. WORKMANSHIP AND INSTALLATION
All work to be completed in accordance with approved shop drawings as modified by field verification and shall be accomplished to the complete satisfaction of the Architect.
Samples of finishes, components, and welds should be submitted for the Architect’s approval prior to beginning fabrication.
Railings shall be installed by the railing manufacturer and installers must have at least five years of experience installing architectural railings.
5. CLEANING AND PROTECTION
The completed railings shall clean all work for inspection and approval of the architect.
The general contractor shall be responsible for protecting the completed railings from stains, scratches or other damage until the project has been completed.
The railing subcontractor shall supply maintenance instructions outlining the proper cleaning products and procedures for the type of railings installed.